Cutting Vinyl Lattice With Hand Saw

The best saw blade for cutting vinyl lattice is one that has small straight teeth not teeth that are hooked or otherwise designed to rip and tear such as saw blades designed to cut through.

Cutting vinyl lattice with hand saw. This is the easiest way to cut vinyl lattice that i ve come across and i wanted to share it with you. I had to replace a couple vinyl lattice sections that w. To cut vinyl lattice attach a vinyl cutting blade to the power saw. You can also use a trim saw or a handsaw.

If necessary walk on the lattice to the side of the lumber opposite the saw and marked line. Have your helper assist you in guiding. On the other hand if you need to cut the plastic lattice into angles and curves you should use a power saber saw. In case you have to do a lot of cutting in straight lines with the plastic lattice the circular saw or power saw with the plastic cutting blade is your best option.

Position the circular saw blade at one end of the lattice sheet lining up the blade with the marked cutting line. Adjust the blade depth on a circular saw by releasing the blade lever on the back. Hold the saw against the lattice as if you were about to cut it then let the blade dip roughly 0 5 in 1 3 cm below the level of the lattice. Squeeze the saw s trigger and move the circular saw slowly along the full length of the marked line.

Start by cutting your vinyl lattice. If you have a helper a table saw is ideal. If you plan to make angled or curved cuts use a power saber saw. If you don t have a vinyl cutting blade you can use another fine toothed blade.

Most of the people who usually need to do it regularly suggests using a circular saw and a sharp and new cutting blade. Ease the saw or blade carefully through the lattice. Some are sold without the support spine allowing no angleing as you cut. Set the blade depth 0 5 in 1 3 cm wider than the lattice s thickness.

A fine blade back saw much like what s used in a miter box. Cut correctly be sure the lattice face side is upward when a fine toothed hard saw is in use. Pvc lattice can be cut with a hand saw circular saw table saw or just about any saw that cuts wood. Cut through the lattice joint by joint using a circular saw with a vinyl cutting blade.